Effect of installed photovoltaic array capacity on the performance of surface pumping systems
Main Article Content
Abstract
This research aims to study the effect of installed photovoltaic (PV) capacity on performance of surface pump powered by photovoltaic array under several heads. The PV pumping system test rig was developed in laboratory and the data collected from the experiments were used for water flow rate prediction. In the experiments, for a particular head, numbers of PV module are varied. The daily water flow rate for each system configuration is also estimated and compared with the others. Finally, the subsystem efficiencies were calculated in order to indicate the effect of installed PV generation capacity. This performance comparison allows the system designers to optimize the PV array sizes to achieve high system efficient and cover their daily water demand.
Article Details
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
References
[2] Igor, J. Karassik, Joseph, P. Messina, Paul Cooper and Charles, C. Heald, Pump Handbook, Fourth edition, 2008, McGraw Hill Companies, New york
[3] Djoudi Gherbi, A., Hadj Arab, A. and Salhi, H. Improvement and validation of PV motor-pump model for PV pumping system performance analysis. Solar Energy, Vol. 144, 2017, pp. 310-320.
[4] Ghoneim, A.A. Design optimization of photovoltaic powered water pumping systems. Energy Conversion and Management, Vol. 47, 2006, pp. 1449-1463.
[5] Protogeropoulos, C. and Pearce, S. Laboratory evaluation and system sizing charts for a second generation direct PV-powered, low cost submersible solar pump. Solar Energy, Vol. 68(5), 2000, pp. 453-474.
[6] Mona, N. Eskander and Aziza, M. Zaki, A maximum efficiency photovoltaic-induction motor pump system. Renewable Energy, Vol. 10(1), 1997, pp. 53-60.
[7] Zaki, A. and Eskander, M. Matching of photovoltaic motor–pump systems for maximum efficiency operation. Renewable Energy, Vol. 7(3), 1996, pp. 279-288.
[8] Betka, A. and Moussi, A. Performance optimization of a photovoltaic induction motor pumping system. Renewable Energy, Vol. 29, 2004, pp. 2167-2181.
[9] Muljadi, E. PV Water Pumping with a Peak-Power Tracker Using a Simple Six-Step Square-Wave Inverter. IEEE Transactions on industry applications, Vol. 33(3), May/June, 1997, pp. 714-721.
[10] Miladi, M., Ben Abdelghani-Bennani, A., Slama-Belkhodja, I. and M'Saad, H. Improved low cost induction motor control for stand alone solar pumping. International Conference on Electrical Sciences and Technologies in Maghreb (CISTEM), 2014, pp. 1-8.
[11] Aashoor, F.A.O. and Robinson F.V.P. Maximum power point tracking of photovoltaic water pumping system using fuzzy logic controller. Power Engineering Conference (UPEC), 2013, 48th International Universities.
[12] Department of Alternative Energy Development and Efficiency, Ministry of Energy. The solar radiation map. Bangkok, 2009.
[13] Janjai, S., Laksanaboonsong, J., Nunez, M. and Thongsathitya, A. Development of a method for generating operational solar radiation maps from satellite data for a tropical environment. Solar Energy, Vol. 78, 2005, pp. 739-751.