SIMULATION SYSTEMS OF BEAM DEFLECTION FOR DESIGN MECHANISM BEAM

Authors

  • Gerametha Sungkasem Lecturer, Department of Mechanical Engineering, Faculty of Engineering, Department of Mechanical Engineering, Faculty of Engineering, Kasem Bundit University, 60 Romklao Rd., Min buri, Bangkok, Thailand 10510,
  • Kriengsak Junseng Lecturer, Department of Mechanical Engineering, Faculty of Engineering, Department of Mechanical Engineering, Faculty of Engineering, Kasem Bundit University, 60 Romklao Rd., Min buri, Bangkok, Thailand 10510
  • Sunan Saranyanit Lecturer, Department of Mechanical Engineering, Faculty of Engineering, Department of Mechanical Engineering, Faculty of Engineering, Kasem Bundit University, 60 Romklao Rd., Min buri, Bangkok, Thailand 10510
  • Thaweesak Manchawanont Lecturer, Department of Mechanical Engineering, Faculty of Engineering, Department of Mechanical Engineering, Faculty of Engineering, Kasem Bundit University, 60 Romklao Rd., Min buri, Bangkok, Thailand 10510
  • Kittisak Kanglah Lecturer, Department of Mechanical Engineering, Faculty of Engineering, Department of Mechanical Engineering, Faculty of Engineering, Kasem Bundit University, 60 Romklao Rd., Min buri, Bangkok, Thailand 10510
  • Prompan sangkeaw Lecturer, Department of Mechanical Engineering, Faculty of Engineering, Department of Mechanical Engineering, Faculty of Engineering, Kasem Bundit University, 60 Romklao Rd., Min buri, Bangkok, Thailand 10510

Keywords:

Beam Deflection, Shear Force Diagram, Bending Moment Diagram

Abstract

Beam Deflection System is a part of theory’s mechanics which is necessarily to study in design for mechanics beam in mechanical engineering. It can be applied for many designs such as cable bridges, frames, and machines. The problems for calculation could be complicated and many methods are involved (only superposition method was selected). The functional using in the software will be receiving the several conditions from toolbox those are 1) Ability is designing by choosing cross-sectional area types Shaft - Beam, I – Beam, and Square-Beam 2) Ability is designing of the beam for the difference type of load action are point load, distributed load and moment Load 3) The alternative options will be provide by choosing simple support or cantilever beams. Finally, the conclusion of the software has two parts 1) Show result by Shear Force Diagram (S.F.D), Bending Moment Diagram (B.M.D) and deflection 2) Show answer of S.F.D, B.M.D and deflection. The results of a software which compared to the calculation is very similar.

References

Beer FP, Jhonston ER. Mechanics of materials. 2nd ed. New York: McGraw-Hill; 1992.

American Institute of Steel Construction (AISC). Manual of Stress Construction. 8th ed. Chicago: American Institute of Steel Construction;1980.

Timoshengo SP, Gere JM. Theory of elastic stability. 2nd ed. New York: McGraw-Hill; 1961.

Downloads

Published

2022-08-31

Issue

Vol. 12 No. 2 (2022): May-August 2565

Section

บทความวิจัย (Research Article)

License

Copyright (c) 2022 Kasem Bundit University

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

*Copyright

            The article has been published in Kasem Bundit Engineering Journal (KBEJ) is the copyright of the Kasem Bundit University. Do not bring all of the messages or republished except permission from the university.

 * Responsibility

          If the article is published as an article that infringes the copyright or has the wrong content the author of article must be responsible.