The Study on Quality of Raw-License Plate : Case Study of Thai, Singapore and Texas, USA.

Authors

  • สุพจน์ ศรีนิล
  • แหลมทอง เหล่าคงถาวร

Keywords:

Education,, Quality,License plate,, Vehicles,, Auction

Abstract

Car license plates are used to identify car information and to manage car.  The Asian Economic Community that will begin at the end of 2014, causes many vehicles running across border.  So quality of license plate and system is important to manage crossing border.  During 2009-2010, the Department of Land Transport (DLT) faced surface of over 300,000 license plates cracking and low quality glaze problem.   So this research aims to study quality specification of raw license plate by comparing between Thai, Singapore and Texas, USA.  The study was done by interviewing DLT officers who is responsible for the procurement, establish the requirements for license plate auction.  Then it was compared to cases study of Singapore and Texas, USA.  These collected data were analyzed by content analysis.  The result of study indicates that Thai Industrial Standard doesn’t specify enough deteriorated resistant of license plate and specification of DLT doesn’t include testing about life and cohesion of license plate sticker.

References

[1] Interview Mrs. S.Wittayanun, Head of Working Capital Section for the making of license plate, and Mrs. S.Somsup, Head of Inventory and License Plates, Department of Land Transport, 31 July 2013 .
[2] American Association of Motor Vehicle Administrators (AAMVA), “Best Practices Guide for Improving Automated License Plate Reader Effectiveness through Uniform License Plate Design and Manufacture”, October 2012.
[3] M. H.Al-Haboubi, “Designing a License Plate,”Applied Ergonomics,Vol.30, pp.421-428 , 1999.
[4] K.Laoprapaipun, and L.Laokongtavorn, “Issues of License Plates Auction and Raw License Plates Cost
Analysis,” The 19th National Convention on Civil Engineering,pp.1403-1411, May,2014.
[5] S. Srinil, L. Laokongtavorn, and S. Kwanpruek, “Study on License Plates Legibility and Recollection,” The 19th National Convention on Civil Engineering, pp.1421-1427, May,2014.
[6] TIS 715-2553, “Thai Industrial Standards, Photo Luminescent Sheeting for making License Plates,” Thai Industrial Standards Institute, 2553.
[7] M. Wong, “Registration & Licensing of Vehicles,” Quota & Registration VRL Service Operation Division, Land Transport Authority, Singapore ,18 October., 2013.
[8] DMS-8390, “Motor Vehicle License Plate Face Materials,” Department Material Specification, Texas Department of Transportation, 2005.

Downloads

Published

2020-06-16

How to Cite

[1]
ศรีนิล ส. . . and เหล่าคงถาวร แ., “The Study on Quality of Raw-License Plate : Case Study of Thai, Singapore and Texas, USA. ”, Eng. & Technol. Horiz., vol. 32, no. 1, pp. 19–24, Jun. 2020.

Issue

Vol. 32 No. 1 (2015): ่๋January - March

Section

Research Articles

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

The published articles are copyrighted by the School of Engineering, King Mongkut's Institute of Technology Ladkrabang.

The statements contained in each article in this academic journal are the personal opinions of each author and are not related to King Mongkut's Institute of Technology Ladkrabang and other faculty members in the institute.
Responsibility for all elements of each article belongs to each author; If there are any mistakes, each author is solely responsible for his own articles.