A Mixed Mode RC Oscillator Using Current Conveyors

Article Sidebar

PDF
Published: Mar 5, 2013

Main Article Content

Adisak Monpapassorn
Assistant professor, Department of Electronic Engineering , South – East Asia University
Sanae Maitreechit
Assistant professor, Department of Electronic Engineering , South – East Asia University
Sakarin Sonanta
Assistant professor, Department of Electronic Engineering , South – East Asia University
Natth Junkrob
Assistant professor, Department of Electronic Engineering , South – East Asia University

Abstract

A mixed mode RC oscillator using current conveyors (CCIIs) is presented in this paper. The proposed oscillator consists of three CCIIs. Two grounded resistors. One ungrounded resistor, and two grounded capacitors. An output frequency can be adjusted by means of a single grounded resistor with independent of the frequency and the condition of oscillation. Both current and voltage outputs are obtained from the proposed oscillator. Simulation oscillator performance using the PSPICE program with a mode of the commercial CCII from Analog Devices demonstrates that the proposed oscillator yields low harmonic distortion outputs

Article Details

How to Cite
Monpapassorn, A., Maitreechit, S., Sonanta, S., & Junkrob, N. (2013). A Mixed Mode RC Oscillator Using Current Conveyors. Engineering and Applied Science Research, 31(2), 191–199. Retrieved from https://ph01.tci-thaijo.org/index.php/easr/article/view/6713
Issue
Vol. 31 No. 2 (2004)
Section
ORIGINAL RESEARCH

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.