A Design of Power Converter Circuit for 1 kW Wind Turbine Generator
Article Sidebar
Main Article Content
Abstract
This paper presents a design of power converter circuits for wind turbine applications. According to the changing of wind speed, the output voltage and frequency of generator are varied and controlled by a power converter, composed of a three phase rectifier, a boost converter with closed loop PI controller and a Pulse width modulation (PWM) Inverter. These systems are implemented in the digital signal system by digital signal processor (DSP). The simulator and experimental results show the benefit of power converter that can control the output voltage up to 600 V with the input voltage about 58-70 V.
Article Details
The manuscript, information, content, picture and so forth which were published on Journal of Engineering, RMUTT has been a copyright of this journal only. There is not allow anyone or any organize to duplicate all content or some document for unethical publication.
References
Johnson, G. L. Wind Energy Systems. England Cliffs: Prentic-Hall, 2001.
Fateev, E. M. Wind Motors and Wind Power Stations.Moscow, 1948.
Mohan, N.; Undeland, T. and Robbins, W. Power Electronics, Converters, Application and Design.New York: John Wiley & Sons, 2003.
สุวัฒน์ดัน,"เทคนิคการและออกแบบสวิตซิ่งเพาเวอร์ซัพพลาย"พิมพ์ครั้งที่ 1, บริษัท เอนเหลไทยจำกัด,
กรุงเทพฯ, 2537.
วีระเชษฐ์ ขันเงิน และ วุฒิพล ราราธีรเศรษฐ์, "อิเล็กทรอนิกส์กำลัง"พิมพ์ครั้งที่ 2,วี.เจ. พรินติ้ง , 2547
http://services.eng.uts.edu.au/~venkat/pe_html/Ch07s3p1.htm
MATLAB User Manual, refer to this website:www.mathwork.com.